Emberglow CCF18NG Guía de instalación descargar pdf (Pagina 4)

D. Prefabricated ﬁ replace. Refer to the manufactures ﬁ replace instruction manual for speciﬁ c information regarding

the running of a gas line into that particular model. A typical prefab installation involves the insertion of a 1/2 inch

gas pipe through the gas line tube provided by each manufacturer from outside the ﬁ replace. The Knockout on the

inside of the ﬁ replace is removed as the gas pipe is punched through the ﬁ replace. (See Figure 3.)

E. Masonry ﬁ replace. A 1/2 inch gas supply line must be provided to the ﬁ rebox. Most installation require drilling an

access hole through the masonry wall. The supply line should be secured and sealed by mortar within the access

hole. The supply line should also have an on-off valve either in the wall or inside the ﬁ replace. (See Figure 4.)

GAS LOG INSTALLATION

(See Figure 1 Parts List as a guide to reference part numbers.)

BURNER PAN INSTALLATION

NOTE: Use pipe compound on all male threads to seal joints.

A. Determine if the ﬁ replace has a right or left-hand gas line feed.

The circular “Dimpled” hole covering must be knocked out on the

appropriate (right or left) side of the burner pan. NOTE: Brace pan

on workbench when removing burner knockout. Strike knockout with

nailpunch for easy removal.

B. Locate 3/8” locknut (Part #12) and washer (Part #21), then fasten

them to the 3/8” brass oriﬁ ce elbow (Part #11). Do not fasten the

locknut on the “ﬂ ared” end.

C. Slide the 3/4” burner support spacer (Part # 10) over the Dual Burner

Bar (Part #9) and move spacer to opposite corner of the gas intake

connection. (See Figure 5)

D. Secure the intake end of the Dual burner bar (Part # 9) to the burner

pan (Part # 8) through the knockout hole selected (right or left hand)

with the 3/8” brass oriﬁ ce elbow (Part # 11) , 3/8” locknut (Part # 12)

and washer (Part #21) previously assembled in Step B.(See Figure 6.)

E. Tighten elbow until ﬁ rmly attached to the Dual burner bar. Then, ﬁ rmly

tighten the attached lockout on the elbow to seal the burner bar to the

wall of the burner pan.

Figure 3. Gas line installation - Prefabricated ﬁ replce

Figure 4. Gas line installation - Masonry ﬁ replce

Figure 5. Burner bar placement

Figure 6. Burner bar connection

1 2 3 4 5 6

Sin comentarios

Emberglow CCF18NG Guía de instalación Pagina 4