Emberglow CSO24NG Guía de instalación descargar pdf (Pagina 4)

D. Prefabricated fireplace: Refer to the manufactures fireplace instruction manual for specific

information regarding the running of a gas line into that particular model. A typical installation

involves the insertion of a 1/2 inch gas pipe through the gas line tube provided by the man-

ufacturer from outside the fireplace.The Knockout on the inside of the fireplace is removed

as the gas pipe is punched through the fireplace. (See Figure 3).

E. Masonry fireplace: A 1/2 inch gas supply line must be provided to the firebox. Most install-

access hole through the masonry wall. The supply line should be

secured and sealed by mortar within the access hole. The supply line should also have a

hole.

shutoff valve either in the wall or inside the fireplace (see Figure 4).

GAS LOG INSTALLATION

(See Figure 1 Parts List as a guide to reference part numbers.)

BURNER PAN INSTALLATION

NOTE: Use pipe compound on all male threads to seal joints.

A.  





Brace panon workbench when removing burner

knock-out.

B.

Locate 3/8” locknut (Part #12) and washer (Part #21), and

attach them to the 3/8” brass ori



fice elbow (Part #11) Do

not fasten the locknut on the “ flared” end.

C.

Slide the 3/4” burner support spacer (Part # 10) over the



Dual Burner bar (Part #9) and move spacer to opposite

side of the gas inlet connection (See Figure 5).



Secure the intake end of the Dual burner bar (Part # 9)

to the burner pan (Part # 8) through the knock-out hole



selected (right or left hand) with the 3/8” brass orifice



elbow (Part # 11),3/8” locknut (Part # 12), and washer

(Part #21) previously assembled in Step B (See Figure 6).

E. Tighten elbow until



firmly attached to the Dual burner bar.

Then, firmly tighten the attached lock-nut on the elbow to

seal the burner bar to the wall of the burner pan.

Figue3. Gas line installation - Prefabricated Fireplace

 

Figure 4. Gas line installation - Masonry Fireplace

Figure 5. Burner bar placement

Figure 6. Burner bar connection

ations require drilling an

NOTE:

Strike knock-out plug with a punch or drift.

1 2 3 4 5 6 7 8 9 ... 15 16

Comentarios a estos manuales

Sin comentarios

Emberglow CSO24NG Guía de instalación Pagina 4

Comentarios a estos manuales